Go To:

Home page

Amp Repair

Amp Tubes




All rebuilds carry a 90 Day Warranty against any defective installed parts. In shop time is from 7 to 10 days.

Please read carefully: the prices quoted assume that your amp is actually rebuildable. Not included in the prices listed below are missing or broken parts, bad transformers or tubes. If your amp has been worked on before, underwater, etc. there may be extra charges. If you are in doubt about the practicality of repairing your amp, please call first. You will be advised of any extra charges BEFORE the work is done.

Packing: life is too short to deal with styrofoam peanuts. Also, blocks or sheets of styrofoam shred small bits that get into controls and tube sockets. For this reason, I will NOT work on any amp that has been packed in styrofoam of any kind. The safest way to ship an amp is to screw it down to a piece of plywood, or attach very heavy cardboard across the bottom to protect it during shipment. Suggested packing materials are bubble wrap, foam rubber, wadded newspapers, cardboard, etc. Do NOT pack your amp in a wood box or crate! Remember that it has to survive a round trip which will include mishandling by the carrier both ways.

A through Continental 2 mono amps $250
Tube type stereo amps from J through TI series $325
Solid state stereo amps from MM-4 through R-83 $350

Countertops $125
All Mono amps $250
(Certain pre-war amps require a preamp, add $75, call first)
All Stereo amps through 474 (48350)  $350

All Mono amps $275
25PAU board set for K and L models  $295
SHFA-1  $475
SHFA-2  $475
All other Stereo amps  $350

TSR-3 & 6; TSU-1 thru 7  $250 (add $95 for stepper service)
TEU board (models K & L) $225
TCC models  $275

P10 through early 1080  $250
Models 660, 661, or 771  $295
All Mono amps including late 1080 with Cobra setup  $275
Stereo amps through 3800 (556 amp)  $350

Please note that return shipping is EXTRA.